A Guide To Fitting An EcoFence

dave — Mon, 11 Oct 2010 14:51:46 +0000

Installation of a Supalite EcoFence is easy and straightforward. All the products are compatible with recognised building and fencing materials and can be sawn and fixed using traditional tools. The following easy-to-understand picture guide provides a detailed summary of installation.

1. PLANNING YOUR PROJECT

Most traditional fence panels are made to a standard 6ft width, and are usually available in four heights – 3ft, 4ft, 5ft & 6ft. If Supalite EcoFence gravel boards are to be used, you should make an allowance of 1ft per board. Posts should usually be 2ft longer than the actual fence height (including the gravel board if used). Supalite EcoFence posts should be concreted 2ft into the ground to ensure that the fence is sturdy.

2. MARKING OUT THE RUN

Establish the line of the fence by stretching a strong cord between stakes at the extremities of the run. Note that the posts should always be on your side of the boundary. Be sure to clear away any plants and vegetation along the line of the fence.

3. MOUNTING THE FIRST POST

The first post will be the datum point for the complete run and therefore must be set accurately and upright. If the fence is running up to the house make sure the first post is securely attached to the building with sleeve anchors. Be sure to insert these directly into the brickwork and not into the mortar.

Sleeve anchors should be spaced no more than 2ft (0.6m) apart with no less than two in total. Drill the holes in the post first and allow only a small clearance over the shank diameter of the anchor bolt. Offer the post to the wall ensuring it is level in both vertical planes and aligned correctly using a spirit level . If necessary use packing between the post and the wall. Bolt the post firmly into position.

If the first post is in open ground it will again need to be upright and perpendicular to the ground in both vertical planes and facing accurately in the correct direction. Mount in rapid set post-mix as detailed below then attach to the first fence panel using 63mm wood screws.

4. FIXING YOUR POSTS IN CONCRETE

Following the line you have marked, using either a post borer or grafter, dig holes to accommodate the posts at a minimum depth of 26″ (650mm). Pack the base of the hole with approximately 50mm of broken brick or stone hardcore to provide initial support for your post.

Utilising wooden braces for support as well as a spirit level, and square for positioning, pack with more hardcore around the bottom of the post leaving approximately 1ft (300mm) for further packing and concrete. When you are satisfied the post is level fill the hole with rapid set post-mix. You should allow a full 24 hours for the concrete to go off and set fully before removing the support braces.

When finishing the concrete around the base of the post, angle the concrete away from the post to allow rainwater to drain away easily.

5. SECURING THE GRAVELBOARD AND FENCE PANEL

Place the gravel board into the ‘H’ slot of the post and align. The gravelboard may be sunk into the ground to provide a more secure fitting.

Secure the post as above, and finally, slot the fence panel between the two posts. If required, cut the posts down to size using standard cutting tools and complete by fitting decorative caps to posts.

6. CREATING A FENCE ON SLOPE

Essentially the methods above can be used to create a sloping fence. Cut your PVC gravel board to shape using standard cutting tools to provide a terrace effect.

Longer fence posts may be required to compensate for the stepped panels. Where possible, attempt to spread the change as evenly as possible over the fence run to provide a more aesthetically pleasing finish.

You can check out our full range of Supalite EcoFence products by clicking the link below.

GO TO THIS CATEGORY

New Supalite Fencing Products

dave — Wed, 06 May 2009 21:00:27 +0000

New to our product range for 2009 is the Supalite wood-grain fencing system. Supalite is incredibly light making general handling and transportation easy. Supalite’s core is manufactured from UVA stable material which will last for a minimum of 20 years, plus the outer composite skin will weather just as timber does and can be re-painted if you so wish. Made with 92% recycled materials, in using Supalite you can be assured that you are protecting the world’s natural resources and helping to preserve the planet for future generations.

The new 92% recycled wood-grain Supalite fence posts and gravel boards are strong, light and easy to install. The following demo shows you just some of the benefits of using the Supalite fencing fencing system in your garden.

FLASH PLAYER IS REQUIRED TO WATCH THIS VIDEO

GO TO THIS PRODUCT CATEGORY
	SUPALITE HAS THE STRENGTH In independent testing Supalite proved that it has a much greater tensile strength than concrete posts, as the combined weight of 56 stone demonstrates!
	SUPALITE WILL NOT CATCH FIRE PVC-s will not support combustion and will only burn within an existing fire. The flame will extinguish when the fire is removed.
	SUPALITE IS ENVIRONMENTALLY FRIENDLY Supalite is manufactured from 92% recycled materials. In using Supalite Fencing Systems you can be assured that you are protecting the world’s natural resources and helping to preserve the planet for future generations.
	SUPALITE IS INCREDIBLY LIGHT At around 5 kilos Supalite is a pleasure to work with. Supalite is incredibly light making general handling and transportation easy. The ease of use means that the health and safety risks ever present with concrete fence posts are eliminated.
	SUPALITE REQUIRES ONLY LOW MAINTENANCE Supalite’s core is manufactured from UVA stable material which will last for a minimum of 20 years, plus the outer composite skin will weather just as timber does and can be re-painted if you so wish.
	SUPALITE CAN BE CUT WITH A HAND SAW Because Supalite is so easy to cut, Gravel Boards can be easily trimmed to suit popular European fence panels which are 1.8m wide. Supalite will also accept screws to secure your fence into position.
GO TO THIS PRODUCT CATEGORY

The Grangewood Blog » supalite

A Guide To Fitting An EcoFence

New Supalite Fencing Products