Some timber fence posts rot prematurely at ground level leaving you with a perfectly good fence that has to be replaced after only a few years! Postsaver ground line barrier sleeves prevent this problem by keeping preservatives in and decay out. They’ll easily double the life of your fence posts, saving you the cost of a full fence replacement and have an expected service life in excess of 15 years.
Patented Postsaver barrier sleeves are a dual layer sleeve comprising a tough polythene outer layer with a meltable bituminous liner; they are all 14’’/350mm long. Postsaver sleeves are quickly and easily heat shrunk on to the vulnerable ground line section of your post using a gas blow torch or pallet shrink gun.
On heating the bituminous liner melts and seals the timber surface whilst the tough outer thermoplastic sleeve shrinks down tightly on to the post. The end result is a tough and durable barrier which keeps the preservative in and the causes of decay out.
|
HOW TO APPLY A POSTSAVER YOURSELF |
The use of Postsaver sleeves typically doubles the life of the fence post. In practice this means a typical expected service life well in excess of 15 years. A claim backed up by nearly 20 years of proven service without failure and exhaustive independent testing.
Postsaver sleeves are easily and quickly applied in 6 to 30 seconds (depending on size of post and power of application equipment) using a low cost off the shelf gas blow torch or pallet shrink gun.
PURCHASE POSTSAVER TO APPLY YOURSELF
Alternatively, POSTSAVER is available pre-applied to the following products;
100MM x 100MM TIMBER FENCE POSTS
125MM x 75MM TIMBER FENCE POSTS
